Rolls of upholstery fabric

How Much Upholstery Fabric Do I Need? Metres for Chairs, Sofas and Cushions

Running out of fabric halfway through a job is one of the most expensive mistakes in upholstery. The extra metres may come from a different dye batch, the colour can be slightly off, and on a sofa that difference shows. Ordering far too much is wasteful too. The answer to "how much upholstery fabric do I need?" depends on the piece, the width of the fabric, the pattern and the way the fabric will be cut. Here is how we estimate it.

Typical metres for common pieces

These figures assume a plain or small-pattern fabric about 140 cm wide, which is the standard width for most of the upholstery fabric we sell. Always confirm with your upholsterer before ordering, because styles vary a lot.

  • Dining chair seat pad: 0.5 to 0.7 metres per chair.
  • Dining chair, seat and back: 1 to 1.5 metres per chair.
  • Bar stool seat: 0.4 to 0.6 metres.
  • Ottoman or footstool: 2 to 4 metres, depending on size.
  • Queen bedhead: 2 to 3 metres.
  • Armchair: 5 to 7 metres. A wingback can need 8.
  • Two-seater sofa: 9 to 12 metres.
  • Three-seater sofa: 12 to 16 metres, more with loose back cushions.
  • 45 x 45 cm scatter cushion cover: about 0.6 metres.
  • 50 x 50 x 10 cm box seat cushion: about 0.9 metres.

When we make cushions for you, we calculate the metres exactly from your sizes, so you never need to work it out. See our custom cushions and custom cushion covers pages.

How pattern repeats add metres

A pattern repeat is the distance before the design starts again, measured down the roll (vertical) and across it (horizontal). Every panel on a patterned piece has to start at the same point in the design so the pattern lines up and sits centred. That means each cut is rounded up to a whole number of repeats.

A simple way to estimate: add one vertical repeat to every major panel. On a sofa with eight main pieces and a 64 cm repeat, that is around 5 extra metres. As a rule of thumb, allow 10 to 15% extra for small repeats and 20 to 30% for large ones. Every fabric on our site lists its pattern repeat in the specifications. Stripes need special care, which we cover in our striped fabric guide.

Railroaded fabric explained

Most fabric is made to run "up the roll": the design runs from the cut edge towards the end of the roll, and you use the fabric in that direction. Railroaded fabric is designed to be turned 90 degrees, so the width of the roll becomes the height of your panel.

Why it matters: a sofa back can be well over 140 cm long. If the fabric runs up the roll, you need a join somewhere across the back. If it can be railroaded, one continuous length of fabric covers the whole back with no seam. On long sofas and banquettes, that can also save metres.

Plain fabrics with no nap can usually be used either way. Fabrics with a pile, such as velvet, or a directional design, such as a botanical, generally cannot be turned without the pile or pattern running the wrong way. If you are unsure, ask us before you order.

Width matters too

Most of our upholstery fabrics are between 137 and 150 cm wide. Wider fabric yields more pieces per metre, so a 150 cm fabric like Warwick Lomani can need a little less than a 137 cm fabric on the same job. Some curtain fabrics come in extra wide widths of around 300 cm, which suits curtains far better than upholstery. See our curtain and drapery fabrics for those.

Why you should buy it all at once

Fabric is dyed in batches, and two batches of the same colour can differ slightly. Buy everything you need for one piece, or one room, in a single order so it comes from the same batch. If you think you may want matching cushions or a footstool later, add the metres now.

Our four-step method

  1. Start from the typical metres above for your piece.
  2. Add extra for pattern repeat or stripe matching.
  3. Add around 10% for waste and mistakes, more for awkward shapes.
  4. Round up to the next half metre and confirm with your upholsterer.

Plain fabrics are the most economical

If budget is tight, a plain or small texture keeps waste to a minimum. Our upholstery fabrics include hundreds of plains, and the sofa and armchair fabrics collection narrows it to fabrics rated for daily use.

Order a sample before the full amount

Before buying 15 metres for a sofa, see the colour in your room. Samples are $7 each, or six for $40. Order from our fabric samples page, then read our guide to choosing sofa fabric.

Common questions about fabric quantities

How much fabric do I need for a three-seater sofa?

Usually 12 to 16 metres of plain 140 cm fabric. Add more for patterns, loose back cushions or a skirt.

Can I buy fabric by the half metre?

Our fabrics are sold by the metre in 0.1 metre steps from 1 metre, so you can order exactly what you need.

What does "railroaded" mean on a fabric?

It means the fabric is designed to be turned sideways, so the roll width becomes the panel height. It avoids joins on long pieces.

Is it cheaper to buy extra fabric now or later?

Buying now is safer. Later orders may come from a different dye batch or the colour may be discontinued.

Back to blog